Fitting Instructions
|
 |
Surface preparation |
 |
Remove any loose paintwork, and repair any flaking surfaces. |
|
Dust down the prepared surface and remove any grease or dirt. |
|
Dampen absorbent surfaces with a water spray, or damp brush. |
| |
|
Adhesive |
|
Mix your heavy duty tile adhesive, Such as Ceresit CM18 or Ardex X7GPlus |
| |
to the desired consistency. |
|
Apply the adhesive to the surface at a depth of 3-4mm to an area you can cover quickly (5-10 tile area.) |
| |
|
Fitting the brick tiles |
|
From the bottom upwards, adhere your brick slips to the desired surface, cutting in where necessary. |
|
Adhere your second course, using your desired bond pattern and using 10mm spacers between courses. |
|
Complete the works whilst the adhesive is still workable.
|
| |
|
Pointing |
|
Once the adhesive is cured point the brick slips using sand cement mortar, or a gun-able mortar such as Easipoint. |
|
Once mortar is touch dry complete desired pointing effect with a steel pointing tool or similar finishing equipment.
|
| |
|
For any technical advise you may require, call us on 0844 7360350.
|
| |
|
 Download Installation Guide |
